How to Replace Riser 2 Blank in a PowerEdge C6620

This video shows the process of removing and installing Riser 2 Blank in a PowerEdge C6620.

In this video, we show how to replace a riser 2 blank on a PowerEdge C6620.

Before removing the riser 2 blank read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety.

For more information about safety guidelines, see the C6620 service manual at Dell.com/Support. In order to remove the riser two blank, you must first remove the expansion card riser.

To remove expansion card riser one remove the three screws that secure the riser to the chassis. Then lift the riser from the connector on the system board.

To remove the riser 2 blank, remove the four screws, securing it to the chassis. Then lift it out of the chassis. To install the riser 2 blank, align the blank with a slot in the chassis and lower into place.

Then tighten the screws, that secure the blank to the chassis. To install expansion card riser one, align the riser with a slot on the chassis and lower until firmly seated.

Then tighten the three screws, that secure the riser to the chassis. For more information or support, visit Dell.com/Support.