Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system
Power off the system and attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
Remove the system cover
Lay the system on its side.
Removing the front bezel:
Lift the retention clips at the edge of the bezel to release the bezel from the system.
Unhook the bezel tabs and pull the bezel away from the system.
Installing the front bezel:
Place the bezel tabs into the bezel slots in the system.
Press the bezel into the system until the retention clips lock into place.
Install the system cover.
Place the system upright on a flat, stable surface.
Reconnect the peripherals and connect the system to the electrical outlet.
Power on the attached peripherals and then power on the system.
