This video covers how to replace a solid state disk internal disk in a Unity x00/F Series, x50/F Series, and 380/F processor enclosure (DPE).
This video covers replacing a faulted M.2 internal disk in your system. Before you begin: Ensure that you always wear proper electrostatic discharge or ESD protection when working inside the system.
First, verify the location of the faulted M.2 internal disk. From the enclosures page, locate the faulted M.2 internal disk, The faulted part is marked in orange in the enclosure view. Make a note of which SP faulted part is in. Next, place the SP into service mode.
The SP fault LED should be alternating amber and blue when the system is in service mode. Now you’re ready to replace the faulted M.2 internal disk. Remove the SP assembly from the enclosure. Make sure you remove the SP that you identified earlier, and do not remove an SP while the Unsafe to remove LED is lit.
Before you remove the SP, first remove the power cord, then label and disconnect any other cables from the network ports. Do not remove the cables from the other SP assembly. Pull the torque limit screw handle out of the SP assembly, then turn it counterclockwise to release the SP from the enclosure. Use the handle to pull the SP out of the enclosure.
Now, place the SP on a flat surface with the top facing up. Wait until all LEDs are off to make sure that the SP is fully powered off. This can take up to three minutes. Push down on the blue release button and slide the top cover back until it stops moving. Then remove the top cover and set it aside.
Now, locate the faulted M.2 internal disk that you identified earlier. Rotate the retaining knob until it comes off the mounting stud. Then, lift the end of the M2 internal disk at a slight angle, and pull it free from the slot. Insert the terminal end of the replacement M.2 internal disk into the slot.
Screw the retaining knob on the mounting hole to secure the M2 internal disk. At this point, you’re all done replacing the M2 internal disk. Align the top cover with the slots on the sides of the assembly. Pull the top cover forward about a half an inch to secure it in place.
Finally, align the SP with the enclosure and slide it in the slot until it stops moving. Then turn the orange screw handle clockwise until you hear a click. Then push the screw handle in until it clicks again.
Finally, reconnect all of the back end cables you removed earlier, and then, reconnect the power cable. Wait about 10 to 15 minutes after reinserting the SP into the system to let the SP fully boot back into service mode. Then, return to Unisphere and reboot the SP into normal mode.
It can take up to 20 minutes for the system to reboot. You should also make sure your new M.2 internal disk is recognized by the system and operating correctly from Unisphere. On the enclosure summary page, confirm that the part’s status is OK. You’ve now replaced a faulted M.2 internal disk.
For more information on adding or replacing other components of the Dell EMC Unity system, go to the Dell EMC Unity Technical documentation page using the link in the description for this video.
