How To Replace Tape Drive for Storage ML3

This video will demonstrate replacement procedure of a Tape Drive for Storage ML3

If you are adding a tape drive, remove a drive bay cover. With a Philips screwdriver, remove one half-height drive bay cover to install one half-height drive, or remove two drive bays covers to install a full-height tape drive.

Note: A full-height tape drive must be installed in the lowest bay of the module.

Align and slowly insert the new tape drive into the drive bay along the alignment rails while the drive assembly is supported. The tape drive must be flush with the back panel of the library.

Tighten the captive thumbscrews with your fingers until the tape drive is secure.

Verify the drive operation.