Removing the Display Bezel
Follow the procedures in Before Working Inside Your Computer:
Ensure that your work surface is flat and clean to prevent the computer cover from being scratched.
Turn off your computer (see Turning Off Your Computer).
If the computer is connected to a docking device (docked) such as the optional Media Base or Battery Slice, undock it.
CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device.
Disconnect all network cables from the computer.
Disconnect your computer and all attached devices from their electrical outlets.
Remove the battery.
Perform the following steps:
a. Pry up the bottom edge of the display bezel.
b. Work your way around the sides and top edge of the display bezel.
Remove the display bezel from the computer.
Installing the Display Bezel:
Place the display bezel onto the display assembly.
Starting from the top corner, press on the display bezel and work around the entire bezel until it snaps onto the display assembly.
Install the battery.
Follow the procedures in After Working Inside Your Computer:
Connect any external devices, such as a port replicator, battery slice, or media base, and replace any cards, such as an ExpressCard.
Connect any telephone or network cables to your computer.
CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into the computer.
Replace the battery.
Connect your computer and all attached devices to their electrical outlets.
Turn on your computer.
