How to Replace Fan Gantry for R750XA

This video will demonstrate the replacement procedure of a Fan Gantry for the R750XA.

Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Removing the air shroud:
Press the latch on the air shroud.
NOTE:To remove left air shroud, press the latch on right air shroud and the opposite way.
Hold the edges of the air shroud, and lift the air shroud out of the system.

Disconnect the cables from system board that pass through the cooling fan cage assembly cable latch.
Open cable access latch to remove the cables and place them towards system front.

Removing the cooling fan cage assembly:
Lift the blue release levers to unlock the cooling fan cage assembly from the system.
Hold the release levers, and lift the cooling fan cage assembly away from the system.

Installing the cooling fan cage assembly:
Align the guide rails on the cooling fan cage assembly with the guides on the system.
Lower the cooling fan cage assembly into the system until seated firmly.
Lower the blue release lever and press to lock the cooling fan cage assembly into the system.

Installing the air shroud:
Align the slot on the air shroud with the tab on the left or right air shroud.
Lower the air shroud into the system until it is firmly seated.

Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.