In this video, we will demonstrate how to replace the M 0.2 22 30 solid state drive with an M 0.2 22 80 solid state drive or SSD before removing the SSD read through the safety guidelines to protect your computer from potential damage and ensure your personal safety.
For more information about safety guidelines see the ran 75 06211 black service menu at dell dot com slash support before you begin, ensure that you turn off your computer and disconnect all attached peripherals, ensure that you create a recovery drive and back up all data.
Before removing the M 0.2 22 30 solid state drive to remove the base cover, remove the six screws that secure the base cover to the palm rest and keyboard assembly. Then loosen the three captive screws that secure the base cover to the palm rest and keyboard assembly starting from the top right corner, use a plastic scribe to pry off the base cover from the palm rest and keyboard assembly, disconnect the battery cable from the system board.
Turn the computer over and open the display. Press the power button for 15 seconds to drain the flea power. Now, let's remove the M 0.2 2002 30 solid state drive first, remove the screw that secures the SSD thermal bracket to the palm rest and keyboard assembly.
Then lift the solid state drive thermal bracket off the palm rest and keyboard assembly. Remove the screw that secures the SSD to the SSD bracket slide and remove the SSD from the SSD slot. You have successfully removed the M 0.2 22 30 solid state drive. Now let's install the M 0.2 22 80 solid state drive.
First, remove the screw that secures the solid state drive bracket to the palm rest and keyboard assembly, then shift the solid state drive bracket to the other side of the solid state drive slot, align the screw hole on the solid state drive bracket with the screw hole on the palm rest and keyboard assembly.
Replace the screw that secures the solid state drive bracket to the palm rest and keyboard assembly align the notch on the SSD with the tab on the SSD slot. Then slide the SSD firmly into the slot at an angle, align the screw hole on the SSD thermal bracket with the screw hole on the palm rest and keyboard assembly.
Replace the two screws that secure the SSD thermal bracket to the palm rest and keyboard assembly connect the battery cable to the system board to install the base cover, align the screw holes on the base cover with the screw holes on the palm rest and keyboard assembly and then snap the base cover into place.
Replace the six screws that secure the base cover to the palm rest and keyboard assembly. Tighten the three captive screws that secure the base cover to the palm rest and keyboard assembly. The M 0.2 2002 80 solid state drive installation process is now complete for more information about this procedure and more see the service manual document at dell dot com slash support.
