Learn how to replace the retractable camera assembly on Inspiron 24 5410, 5411, 5415, and 27 7710 All-in-One computers.
This video shows how to replace the retractable camera assembly on Inspiron 24 5410, 5411, 5415, and 27 7710 All-in-One computers. Before you begin, power off the computer and disconnect all the attached peripherals, remove any SD card installed in the SD card slot on your computer. Ensure that you always use ESD protection when working inside the computer.
To begin, place your computer on an elevated, clean, and flat surface. Place the display flat on the surface with the stand hanging over the edge. It is recommended to remove the stand to avoid accidental damage to the computer display when servicing. To remove a stand, locate the tab on the stand, and push a scribe into the tab. This will release the stand from the display-assembly base. Similarly, remove the other stand.
Next, remove the back cover. To do so, place your palm on the middle of the back cover, and then pry the back cover from the display-assembly base starting from the top corners. Then, lift the cover off the base. Next, remove the five screws that secure the I/O cover to the display-assembly base. Then, lift the cover off the base. Next, remove the four screws that secure the system-board shield to the display-assembly base.
Then, lift the shield off the base. Next, disconnect the camera cable from the system board. Peel the tape that secures the camera cable to the display-assembly base. Now, remove the two screws that secure the retractable-camera assembly to the display-assembly base. Then remove it from the base. You have successfully removed the retractable-camera assembly. Now, let’s install the retractable-camera assembly. Slide and place the retractable-camera assembly on the display-assembly base.
Replace the two screws that secure the assembly to the base. Next, adhere the tape that secures the camera cable to the display-assembly base and connect the camera cable to the system board. Now, let’s replace the system-board shield, I/O cover, back cover, and stand. Align the slots on the system-board shield with the ports on the computer. Replace the four screws that secure the shield to the base.
Align the screw holes with the I/O cover with the screw holes on the display-assembly base. Replace the five screws that secure the cover to the base and snap it into place. Align the slots on the back cover with the slots on the computer, and press along the sides to snap it into place.
Now, insert the stand into the slot on the back cover until it snaps into place on the display-assembly base. In a similar way, fix the other stand. The retractable camera assembly installation process is now complete. You can now connect all the peripherals. If you need more information or assistance, go to dell.com/support/
