Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system.
Turn off the system, including all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
Remove the system cover.
If installed, remove the risers.
Removing the LOM riser card:
Using a Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the system board.
Release the two blue side plastic snaps holding the LOM riser card.
Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
Slide the LOM riser card towards the front of the system until the Ethernet connectors or the Small form-factor pluggable (SFP) are clear of the slot in the back of the system.
Installing the LOM riser card:
Align the connectors on the LOM riser card with the slot on the system.
Press the LOM riser card until the card is firmly seated on the system board connector and the two blue plastic snap hold the LOM riser card in place.
Using a Phillips #2 screwdriver, replace the screws to secure the LOM riser card to the system board.
If removed, install the risers.
Follow the procedure listed in After working inside your system
Install the system cover.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the attached peripherals and then turn on the system.
