Prerequisites
Use SupportAssist to send diagnostic data to technical support.
Change the operation mode of the Storage Center to Maintenance.
Remove a Hard Drive:
Remove the front bezel.
Extend the expansion enclosure chassis from the front of the rack.
To release the hard drive, push the orange release tab on the drive carrier towards the front of the expansion enclosure.
Lift the latch on the drive carrier and slowly pull the drive up approximately 3 cm (1 in.).
Install a Hard Drive:
Open the latch on the drive carrier.
Align the drive with the guides and gently lower the disk into the slot. The latch begins to close when the drive carrier meets the backplane.
Push down on the latch tab to engage the latch.
When the latch is engaged, push on the drive carrier to verify that the drive is properly seated.
Wait for the expansion enclosure to recognize the hard drive and determine its status.
Push the expansion enclosure chassis back into the rack.
In Storage Manager, make sure that the hard drive is recognized and shown as up and running.
Use SupportAssist to send diagnostic data to technical support.
Change the operation mode of the Storage Center to Normal.