Unsolved
This post is more than 5 years old
59 Posts
0
12260
Can a 9450XE be flashed using the USB firmware tool, or only via WSI?
Can a 9450XE be flashed using the USB firmware tool, or only via WSI?
Hello All:
I did a LOT of reading on this, but it is still not clear.
Can a 9450XE be flashed using the USB firmware tool, or only via WSI?
Any information on this would really be appreciated!
Lee
jpropsner
67 Posts
0
July 8th, 2015 09:00
The V90LE and 9240 do not use the same flash drive. The V90LE is Eide. The 9150 is IDE.
lee_leses
59 Posts
0
July 8th, 2015 09:00
Thank you, I wrote a reply on the other thread!
jpropsner
67 Posts
0
July 8th, 2015 09:00
The 9450xe can only be imaged with WSI or Wyse Device manager. USB imager does not support that unit.
lee_leses
59 Posts
0
July 8th, 2015 09:00
Thank you.
I will have to do a fair amount of reading before I'm ready to try that method.
The reason I wanted to know is I want to figure out if I could pull the image off the 9450 and use it's 2GB flash drive in a V90LE, then push the 9450 image back on to a 1GB flash drive.
But I'm not sure if the V90LE and the 9450 use the same type of flash drive?
Lee