This post is more than 5 years old
52 Posts
0
3307
SnapView required for SRM and MirrorView
Was just thinking about the process of SRM with MirrorView /S on a VNX/CX. Would SnapView be required for a customer who wants the ability to execute a test of the recovery plan in SRM? I'm assuming it would, since the test would leverage a writeable snapshot at the DR site. If they never wanted to test (highly unlikely), then I'm assuming it would work without the SnapView license?
Jingyi1
199 Posts
0
April 25th, 2012 23:00
Slowrider, you are right about this. SnapView snapshot is need to be created on the secondary storage system for testing purpose. You can find more information on
MirrorView Adapter for VMware Site Recovery Manager Release Notes
Please read "Configuring the storage for Site Recovery Manager" part on page 12
During failover testing, the MirrorView Adapter uses SnapView snapshots. When you create a SnapView snapshot of a LUN for a virtual machine, the name of the snapshot must include the following text string: VMWARE_SRM_SNAP. During failover testing, the MirrorView Adapter looks for this text string in the name of the inactive snapshot(s) for the virtual machine LUN(s) and creates a consistent snap session for this snapshot(s). When failover testing is finished, the MirrorView Adapter stops the SnapView session automatically.
kangw2
28 Posts
0
April 24th, 2012 23:00
It is a little fresh, we will make some research and get back to you.
zhaos2
2 Intern
2 Intern
•
643 Posts
1
April 25th, 2012 01:00
The SnapView is required for testing failove and testing failback as SRM needs the snapshots for test scenarios. But if you are not going to do test, I don't think you need the SnapView.
Please refer to the below link for more information:
http://communities.vmware.com/thread/188971
http://viops.vmware.com/home/docs/DOC-1227
LouisLu
161 Posts
1
April 26th, 2012 00:00
Slowrider, further explanation on difference between executing SRM recovery plan and testing the environment:
More EMC-Clariion-VMware-integration go to:
http://www.emc.com/collateral/hardware/white-papers/h1416-emc-clariion-intgtn-vmware-wp.pdf
TylerTech-Hanse
1 Message
0
August 1st, 2012 07:00
I have successfully run a test recovery using a CX4-120 at our recovery site with a VNX 5500 at our production site. Snapview seemed to do just what it needed to do for the test and everything went well. I was curious though and I cannot seem to find any documentation on this.... do I need to remove my snapshot after I do the test? or do I just use the same snapshot over and over for my testing? We will need to do quarterly test recovery so not sure if I need to do a snapshot each time or just the one for each lun once... Any thoughts?
Thanks
Toby