Unsolved
This post is more than 5 years old
7 Posts
0
3888
Open Replicator - How to find WWN LUN ID
I'm using Open Replicator to migrate off of HDS AMS1000 arrays to VMAX. While I can use SMC (aka the GUI) to set up the sessions, I'm much more comfortable in the CLI. Also, using the CLI allows me to pre-script the changes and ensure I have everything correct before I execute. Where I'm stumbling is in the pairs file contents. I know the syntax is
symdev= : wwn=
Where I need some help is on the wwn side of things. I'm not sure how to find the WWN of the LUN. I can't find it on the AMS anywhere, and I'm not sure what command to use on the Symmetrix to see the available LUNs to create the session with. I know they exist on the Symm because I can see them in the GUI, but when I try to use the device ID that is shown in the GUI it fails out. Any help here to determine the WWN LUN ID of the remote array for a hot pull would be appreciated.
FYI, I've already read the tech books and SYMCLI guide. It was not clear from those, so please don't post to read the manual.
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
August 4th, 2011 10:00
typically you would use "symdev list -sid -noport" to list devices that are not mapped to any FAs. You can append -FA and -P to narrow it down to specif FAs/ports. Once you find your devices you can run "symdev show -sid #device" and grep/find for WWN.
McNally
7 Posts
0
August 4th, 2011 10:00
I had a friend get back to me on this and here is the answer. Use symsan to determine the WWN of the available LUNs for migration.
symsan list -sid -sanports -dir
using the output of this, run the following to get the LUN WWN ID
symsan -sid list -sanluns -wwn -dir
Use the LUN WWN column as the WWN ID after the wwn=
Now that the pairs file is properly populated the symrcopy create will work!
vijay861
51 Posts
0
August 4th, 2011 14:00
Hi Mc Nally,
You can find the WWN of LUN ID as discussed by other participants...
You can also create Open Replicator Sessions without WWN of LUN ID.
Control symmetrix Target symmetrix
symdev= : symdev= :
I know there is another way of creating the text file for OR sessions
Control symmetrix Target symmetrix
symdev= : WWN of LUN ID< target device>
Choose which way is better to you.
MorbidAngel1
62 Posts
0
August 7th, 2011 23:00
Hi,
The below command will give any Lun WWWN.....
symdev -sid XXXX list -wwn & then grep for the specific source and Target Decvice,