Unsolved
This post is more than 5 years old
8 Posts
0
16182
Open manage 5.4 downloaded and can't burn image
Hi all,
I have downloaded four iso of openamange 5.4 that needs to be combined together to burn into one dvd, but not sure how to do it. I planed to do it with daemon tool, opening all four iso and put them together and create new iso with magiciso then burn it. But when i mount 2,3,4 iso's it says iso is not valid image. When first time this happened i thought might be bad download so i downloaded again but same thing happend agail.
So can some one please explain how to put those four iso together in one dvd? or how it is intended to be used?
Also i want this to setup server 2008 in poweredge 2950. using 32 bit pc and iso is for 64 bit(selected server 2008 X64 to download)
Thanks
Message Edited by member001 on 09-13-2008 10:00 AM
DELL-Jeff M
2 Intern
2 Intern
•
793 Posts
0
September 14th, 2008 21:00
dnaren
4 Posts
0
September 15th, 2008 22:00
I used the following command and the resulting is not a valid iso image according to Nero:
copy /b om_540_smtd_a01.iso.001+om_540_smtd_a01.iso.002+om_540_smtd_a01.iso.003+om_540_smtd_a01.iso.004 om_540_smtd_a01.iso
amackan
8 Posts
0
September 29th, 2008 13:00
member001
8 Posts
0
September 29th, 2008 16:00
amackan
8 Posts
0
September 30th, 2008 13:00
amackan
8 Posts
0
September 30th, 2008 14:00
Hi, yes i did exactly that, but once i open nero and select burn image, it displays that its not a valid image.
i have 4 x .iso.001-4 files about 585MB each
Thanks again
member001
8 Posts
0
September 30th, 2008 14:00
Those 4 files are segment files and above commands will create 5th file in the same folder that's the complete iso. So new 5th one can be burned.
member001
8 Posts
0
September 30th, 2008 14:00
Give it one more try, it does work. Did you go to that folder before running copy command ?
Download or copy all ISO file segments into an empty subdirectory on your local hard drive. After you have downloaded all the file segments, run the following command to create the ISO file:
open command prompt
change folder to iso segments folder
cd %folder%
Once in the folder Use following to create one iso.
copy /b om* om_540_smtd_a01.iso
Use your DVD burning software to create a DVD from om_540_smtd_a01.iso.
nichomach
34 Posts
0
October 20th, 2008 13:00
Suggestion; rename the resulting image file to remove the underscores. Yes, Nero really IS that dumb. That said, Ashampoo Burning Studio 2009 burned the image as was, but the resulting disk was a coaster. With the underscores removed, the image appears to not only burn in Nero 6 but be readable afterward.
edit: I should note that this is with v5.5 of the DVD