Unsolved
1 Message
0
634
Assistance
Good day,
My projector has been working perfectly all the years, but recently when i wanted to use it, it didn't work.
Normally I would connect the charger, connect the projector to my laptop and then press the start/on button. In just a little while the screen image will pop up against the wall and all is good to go.
This time I did the same, but when I pressed the "on" button and it looks like it is on (on button not flickering anymore), the "menu" button is also on and stays on no matter I do (like pressing and holding it etc.) and no image appears on the wall.
I put the projector off and on again and same issue persists.
Please assist.
Regards
vishvajitd
2 Intern
2 Intern
•
278 Posts
0
March 14th, 2023 23:00
It sounds like there may be an issue with the projector's display or input settings. Here are a few things you can try to troubleshoot the issue:
Check the input source: Make sure that the projector is set to the correct input source, such as HDMI or VGA, and that your laptop is also set to the correct output source.
Check the cables: Check that the cables connecting the projector to your laptop are securely plugged in and not damaged.
Check the display settings: Try adjusting the display settings on your laptop to see if that helps the image appear on the projector. You may need to adjust the resolution or aspect ratio.
Reset the projector: Try resetting the projector to its factory settings. This can usually be done by accessing the projector's menu settings and selecting "reset" or "default".
If none of these solutions work, it may be a hardware issue with the projector itself and you may need to contact the manufacturer for further assistance or take it to a professional technician for repair.