Powervault ME4012 / ISCSI config save issue

Hello,

I'm new to Dell and ISCSI, and my issue is most likely due to me not fully understanding what i'm doing, hence i would immensely appreciate the help!

A brand new Powervault ME4012, still in the setup wizard won't save my ISCSI config.

I watched several youtube movies, and read the deployment and admin guide but whatever i try, it simply won't accept my ISCSI config.

4 of the 8 interfaces are connected to a single Dell N4032F. Ports are untagged in Access in a dedicated VLAN.

I know this isn't best practice, but this is a very temporary situation which will be resolved in two months. To my understanding this should work, eventhough it's far from ideal.

I have tried with subnets 10.2.1.0/24 and 10.2.2.0/24, with and without a gateway entered. i have tried the exact ip's from this video (https://www.youtube.com/watch?v=03mosqjdeHQ), but whatever i try, when i press apply and close... nothing happens. No error either.

I know it's my fault, but i can't piece it together.

Much appreciate any help.

Thanx!

Peter