Unsolved
1 Rookie
•
1 Message
0
44
the error message of poweredge 2950 remote access controller detected
Hi everyone
plz helper me
when I turn on my server I just receive this message (remote access controller detected) and it is not continue
Unsolved
1 Rookie
•
1 Message
0
44
Hi everyone
plz helper me
when I turn on my server I just receive this message (remote access controller detected) and it is not continue
Top
DELL-Charles R
Moderator
Moderator
•
3.8K Posts
0
February 13th, 2024 13:56
Hello,
Was this server working and now is not?
If so; what was done on the server around the time this started happening?
Could you post image of the error you are seeing?
Initially I can recommend a flea power drain and check results after.
drain flea power (shut down, disconnect power cables and Network cables, hold in power button 20 seconds with cords removed). After flea power drain, system has to set for 3 minutes for DRAC to reset without any power plugged in, then plug in NIC and power but wait 2 minutes before power on to give DRAC time to initialize.