Unsolved
1 Rookie
•
2 Posts
0
16
T430 local video black
I bought a used T4340 server. iDRAC8. Server 2016 installed. 8GB. RAID
Working when removed.
Screen goes black after POST, but monior light indicates signal is present after POST.
It appears lodal video out is disabled.
I can't get BIOS setup to display with F2 or Boot menu to display w/F11. Just black after pressing keys.
I have tied resettging with BIOS jumper, also removing BIOS battery,
I do see the F2, F11, F12 chouces briefly during POST, but then black.
Any suggestions on how to get to BIOS?
iDRAC access is fine, but no virtual console license, so I can't set local video from iDRAC, as far as I can tell.
Thanks
Cyinnm
1 Rookie
1 Rookie
•
2 Posts
0
September 30th, 2024 22:38
Clarification:
It is a T430 tower server. not "T4340" sorry for typo
Dell-Martin S
Moderator
Moderator
•
3.3K Posts
0
October 1st, 2024 13:28
Hi,
Here are some steps you can try:
1. Check Video Cable and Monitor:
Ensure that the video cable (VGA, DVI, or HDMI) is securely connected to both the server and the monitor.
Try using a different monitor or video cable to rule out any hardware issues.
2. Verify BIOS Settings:
If you can access the iDRAC, you might be able to check the BIOS settings remotely to see if the local video output is enabled. Look for options related to video or display settings.
If you can't access the BIOS through iDRAC, try the following:
Reset CMOS: Remove the CMOS battery (a small, round battery on the parentboard) and wait for a few minutes before reinserting it. This should reset the BIOS settings to their defaults.
BIOS Jumper: If your parentboard has a BIOS jumper, check the manual for the correct configuration to reset the BIOS.
3. Update BIOS:
If you can access the iDRAC, check for any available BIOS updates for your T430 server. Updating the BIOS can sometimes resolve hardware or software compatibility issues.
4. Inspect Hardware:
If the above steps don't work, carefully inspect the parentboard for any visible damage, loose components, or corrosion. Pay attention to the video output section.
If you find any issues, consider seeking professional assistance or replacing the faulty component.
5. Try a Different Operating System:
If the issue persists even after trying the previous steps, try installing a different operating system (e.g., Ubuntu Server) on a USB drive and booting from it. This can help isolate whether the problem is hardware-related or software-specific to Windows Server 2016.