NEW DELL R740 STUCK ON CONFIGURING MEMORY

Hello,

Do you know the history of this R740?

Has it been working and now it does not?

What was done on the system around the time the issue started?

From the image I can tell it is not completing POST.

First couple steps I can recommend it to drain the flea power and check results.

If it doesn't complete POST then try clearing the NVRAM and check results.

drain flea power (shut down, disconnect power cables and Network cables, hold in power button 20 seconds with cords removed). After flea power drain, system has to set for 3 minutes for DRAC to reset without any power plugged in, then plug in NIC and power but wait 2 minutes before power on to give DRAC time to initialize.

Check results.

Clear NVRAM - there is a map under the lid to show the jumper location. Shut down, Set jumper to the Clear position, power on and Post up to the jumper error, shut down and return jumper to original location.

Check results.

@DELL-Charles R​ Thank You for Answer

I have follow your instruction , but still stuck on Configuring Memory........ done

server have blinking pleace cek the video

Hi,

could you please answer the questions from Charles?

We need this for further TS steps.

Do you know the history of this R740?

Has it been working and now it does not?

What was done on the system around the time the issue started?

I also got the same problem, I solve it by cleaning the server ram with the eraser