Unsolved
This post is more than 5 years old
1 Message
0
1347
Stack N1500 withjust 2 10Gb ports
Hi,
I have a stack with two N1500 switches it works ok. See config :
console#show switch stack-ports
Configured Running Link Link Admin
Interface Stack Mode Stack Mode Status Speed (Gb/s) Status
--------- ---------- ---------- ------------ ------------ ------------
Te1/0/1 Ethernet Ethernet Link Up 1 Disabled
Te1/0/2 Ethernet Ethernet Link Up 1 Disabled
Te1/0/3 Ethernet Stack Link Down 10 Enabled
Te1/0/4 Ethernet Stack Link Up 10 Enabled
Te2/0/1 Ethernet Ethernet Link Up 1 Disabled
Te2/0/2 Ethernet Ethernet Link Up 1 Disabled
Te2/0/3 Ethernet Stack Link Down 10 Enabled
Te2/0/4 Ethernet Stack Link Up 10 Enabled
I have just one stack cable, but the config makes a ring stack and uses ports 1/0/3 also on both switches, can i reconfig the stack so that i can connect servers over tengigabit ports 1/0/3 and 2/0/3 or some switches so that the stack uses just port 1/0/4 and 2/0/4 and not ports 3 this ports i want to use for switches or servers because i have to many sfp links in this moment.
When i config the ports not to stack but in to ethernet will the stack after a reboot still work or is then just a switch to switch link and not a stack.
Regards
Peter