N1500 Config

Hello!

I have a small question if my config looks good.
My setup is four N1500 switches that are stacked with stacking cables.
I also have two uplinks, one to switch 1 and one to switch 2, uplink 2 is passive.

Now I'm wondering if I've missed something in my configuration.
I don't think it really works as it should, as some clients sometimes end up in Blocking mode. and then the active/passive function does not work any further well. it takes a few seconds before the passive becomes active and then when the active becomes active again, it is still on the passive.

!

enable

Configure

!

interface vlan 1

ip address 192.168.80.22 /24

exit

!

ip default-gateway 192.168.80.1

!

ip route 0.0.0.0 0.0.0.0 192.168.80.1

!

hostname EA8022SW

<Private data removed from public view. DELL-Admin>

!

Stack

Stack-port tengigabitethernet 1/0/1 stack

Stack-port tengigabitethernet 2/0/2 stack

Stack-port tengigabitethernet 3/0/1 stack

Stack-port tengigabitethernet 4/0/2 stack

exit

exit

!

Configure

ip ssh server

!

snmp-server location CityAndInfo

snmp-server contact IT

snmp-server view sview system included

snmp-server group v-group v3 priv notify Default read DefaultSuper write Default

snmp-server user v-user v-group auth-md5 lknsad7823kbnsdaf priv-des LRnslkdfhCG

!

eula-consent support-assist reject

eula-consent hiveagent reject

no ip telnet server

!

flowcontrol receive on

Y

!

spanning-tree portfast default

spanning-tree mode RSTP

!

ip http server

!

classofservice trust ip-dscp

classofservice ip-dscp-mapping 24 5

classofservice ip-dscp-mapping 40 5

cos-queue strict 5

!

sntp unicast client enable

sntp server se.pool.ntp.org poll

sntp server 192.168.1.15 poll

clock timezone +1 zone EU

clock summer-time recurring EU

!

exit

!

configure

!

interface range gigabitethernet all

speed auto

green-mode energy-detect

switchport voice detect auto

!

exit