Dell PowerConnect 5548P Commands

Question

I am looking for the following commands: - show all trunk interfaces without checking the ports one at the time - last time port transmitted traffic without checking the ports one at the time

DELL-Josh Cr · Accepted Answer

Hi Rudy,

You may be able to do a range for show interfaces switchport, but it doesn’t say in the manual. For the last time it transmitted traffic I haven’t found a command that let’s you do that. Let us know if you have any additional questions.

Rudy2020 · Answer

Thanks for replying, but not quite I am looking for. For instance, Cisco has the following command: (show interface trunk) and this shows all trunks interfaces.

DELL-Josh Cr · Answer

There is not a command like that on this switch. https://dell.to/2WDyDjs

DeweyBeck · Answer

Your article is so useful for us,thanks for sharing. Good stuff!

Networking General

Dell PowerConnect 5548P Commands

Was this post helpful?