Unsolved
This post is more than 5 years old
9 Posts
0
1393
cannot update EBR configuration
hi everyone,
after password'Vcenter user changed, i have updated infor in EBR configuration. https://ebr.doman:8543/ebr-configure,
but when i saved, i get error as below:
EBR: Starting vCenter Reconfiguration service
EBR: Validate vCenter credentials..
EBR: Validate vCenter credentials failed.
Could anyone suggest me to resolve this issue?
thanks,
Kleinenbroich
86 Posts
0
September 12th, 2016 05:00
Hi,
not sure whether I understood the your requirement correct. But if you're changing the password of the vCenter user used for the EBR integration I suggest the following workflow:
Are you executing those steps and afterwards you receive the "EBR: Validate vCenter credentials failed" message?
For further investigation you might think about creating a new vCenter user account (check "NetWorker and VMware Integration Guide.pdf")
Regards
Michael
nguyentm
9 Posts
0
September 12th, 2016 18:00
hi Michael,
yes, i have done the steps that you recommend, and i receive error: EBR: Validate vCenter credentials failed.
Vcenter user has full permission and it work fine before.
tks
Kleinenbroich
86 Posts
0
September 26th, 2016 03:00
Hi,
could it be, that the vCenter was updated meanwhile (after last successful login)? E. g. from vCenter 5.1 to vCenter 5.5?
Regards
Michael
Kleinenbroich
86 Posts
0
September 28th, 2016 08:00
Hi,
with my current setup (NW 8.2.3.5, VBA-1.1.3.7 with VBA-1.1.3.7-Bravo-TLA path) I had the same issue. It was caused by a temporary not working DNS server.
Regards
Michael