This post is more than 5 years old
1 Rookie
•
7 Posts
0
21422
December 7th, 2012 03:00
Battery Light (amber) flickering continuously
Hello everyone,
I have a Studio 1458. My battery got drained of charge while using the laptop. It has happened in the past too which is quite normal. But this time, the battery isn't responding. When I plug-in the charger, the amber light starts to flicker continuously. On start-up it says 'Warning! Battery critically low. F1 to continue.'
On doing so, system starts up normally but the light continues to flicker. I've removed the battery and now using directly on the AC Charger and it is working fine. I am clueless about the problem. Is it with the battery..the battery charger combination or something with the motherboard?
- Ayush M.
DELL-Appu S
4 Operator
4 Operator
•
3.1K Posts
1
December 7th, 2012 03:00
Hi Ayushmishra,
I would recommend you to update the BIOS of the computer.
Note: Before updating BIOS please ensure that:
*Battery is 10%> or >10% charged
*Battery charger should be connected
*No external devices (flash drives, printers, external hard drives) should be connected.
*All other programs should be closed and documents saved
Alternatively. check the battery health:
If you are not able to see ‘Dell Health Meter’, then install Dell Quickset on your computer. Here are the steps:
In case you do not get prompts on the screen for instructions, then
Please reply if you have any questions.
DELL-Appu S
4 Operator
4 Operator
•
3.1K Posts
1
December 11th, 2012 01:00
Hi Ayushmishra,
Thank you for your response. It seems to be an issue with the battery or the motherboard. I would recommend you to replace the battery and check it works. If replacing the battery does not resolve the issue, then the motherboard may have to be replaced.
Glad to assist.
ayushmishra
1 Rookie
1 Rookie
•
7 Posts
0
December 7th, 2012 04:00
Hello Appu S,
Thanks for your response. I tried connecting my battery and checked in the battery meter. It is not showing anything. Not a red icon, not even as it used to show earlier.
Now, I'll go ahead with the BIOS update thing. Before I can go further, there is a query; The point you mentioned about the battery charge status before the BIOS update thing, what should I do about that. When I connected the battery and hovered over the cursor, it says 'Plugged In but not Charging'.
Thanks & Regards,
Ayush M.
ayushmishra
1 Rookie
1 Rookie
•
7 Posts
0
December 7th, 2012 06:00
I am awaiting your response on my last post. Since my battery isn't working, should I carry on the BIOS update on the direct charging way?
DELL-Appu S
4 Operator
4 Operator
•
3.1K Posts
0
December 7th, 2012 06:00
Hi Ayushmishra,
Thank you for your response. I appreciate the information provided. Please share the status once you have updated the BIOS. I would recommend you to check if the charging port on the laptop is loose. Connect an alternate AC adapter to see if that works fine with the system. Do you see a light on the AC Adapter? If yes, please follow the below steps:
Please check the status of the AC Adapter in BIOS:
Hope this helps. Please reply if you have any questions.
ayushmishra
1 Rookie
1 Rookie
•
7 Posts
0
December 7th, 2012 06:00
I still haven't started the update process.
Currently, the AC Adapter status is 90W
ayushmishra
1 Rookie
1 Rookie
•
7 Posts
0
December 8th, 2012 06:00
Should I proceed with the BIOS update without the battery attached or should I attach it no matter its condition?
DELL-Appu S
4 Operator
4 Operator
•
3.1K Posts
0
December 10th, 2012 02:00
Hi Ayushmishra,
Thank you for your response. Battery is required to update the BIOS. I would recommend you to connect the battery and check the battery health and then proceed with the BIOS update.
Note: Before updating BIOS please ensure that:
*Battery is 10%> or >10% charged
*Battery charger should be connected
*No external devices (flash drives, printers, external hard drives) should be connected.
*All other programs should be closed and documents saved
Please reply with the status.
ayushmishra
1 Rookie
1 Rookie
•
7 Posts
0
December 10th, 2012 06:00
I tried to run BIOS update after connecting the battery and the charger, but I cannot proceed.
Battery health is showing to be at 0% without any red icon or notice regarding Change Required.
Further when I am trying to run the BIOS update here is what coming up:
"The battery must be charged above 10% before the system BIOS can be flashed.
Press OK when the battery is charged or CANCEL to quit."
I tried pressing OK but it doesn't proceeds as the battery isn't charging and the amber light is continuously flashing.
Please recommend what to do. Urgent reply would be appreciated.
Thanks
ayushmishra
1 Rookie
1 Rookie
•
7 Posts
0
December 13th, 2012 13:00
I tried booting up with another Studio 14's battery and it Worked! :)
So it seems my original battery is dead now and I need to order a new one!
Hope there isn't any other issue!
Thanks a Lot!
Your support has been tremendous!
DELL-Appu S
4 Operator
4 Operator
•
3.1K Posts
0
December 14th, 2012 02:00
Hi Ayushmishra,
I am glad the issue is resolved. Do write back in case you need any further assistance.