Unsolved
This post is more than 5 years old
18 Posts
0
482
SAR and "Parsing error"
Greetings.
I'm running a SAR-process with ResourcePak Base V5.5.0. The SAR-monitor in EMCTOOLS is telling me that this process has an "Ending Status" of "PAR" which seems to indicate that "The process had a parsing error".
But this SAR-process seems just fine. It's "Active" (as shown in the monitor itself) and very much "up and running". So why is the dialog reporting an "Ending status" and just what is this "Parsing error" it's talking about?
Willem Vermeer
ING Bank
Amsterdam, the Netherlands
I'm running a SAR-process with ResourcePak Base V5.5.0. The SAR-monitor in EMCTOOLS is telling me that this process has an "Ending Status" of "PAR" which seems to indicate that "The process had a parsing error".
But this SAR-process seems just fine. It's "Active" (as shown in the monitor itself) and very much "up and running". So why is the dialog reporting an "Ending status" and just what is this "Parsing error" it's talking about?
Willem Vermeer
ING Bank
Amsterdam, the Netherlands
Davidy8s
154 Posts
0
October 9th, 2007 12:00
This is fairly old posting, and I apologize that there has been no response until now. If this problem is still persistent, I'd ask that you open a serivce request to facilitate resolution.
Best regards,
Dave Yates
EMC TS2
Host S/W Mainframe Mod.
WillemV1
18 Posts
0
May 3rd, 2010 04:00
This issue isn't relevant anymore, since we have gone over to another supplier for our mainframe-storage.