Centera interface FPZSTUB hangs when executed from an APF lib on z/OS

Question

Hello, First please let me apologize if I have selected incorrect software, this is a first for me! The problem we are having is as follows: we use the Centera SDK version 3.1.477 with our application in IBM z/OS 1.9 environment. When the SDK library gets APF-authorized, we are experiencing a 'hang' in FPZSTUB when initializing the Centera interface. The specific call I believe is FPPool_GetPoolInfo, which causes an implicit FPPool_Open in FPZSTUB. 9 Call FPZSTUB n/a n/a M+31C Not determined 10 Call LSCSGNL n/a n/a M+2316 Not determined 11 Call LSCSGNL n/a n/a M+52C8 Not determined 12 Call LSCSGNL n/a n/a M+4AC6 Not determined 13 SVC LSCSGNL n/a n/a M+4EE6 Not determined 14 Call IGC0101C n/a n/a M+12976 LPA That call never completes causing eventually the job to be terminated with abend S522. I attempted to enable SDK logging be means of an FPCONFIG DD but nothing came out. Would you be able to offer any advice? Thanks, Greg

Davidy8s · Answer

Greg,

Apologies for missing this earlier. I'll see if we can get some C* guys to dig into this.

Looks like we have a pair of service requests open to address this now.

Message was edited by:
Dave Yates
EMC TSE3
Benevolent Host S/W & Mainframe Forum Moderator

Davidy8s · Answer

Issue resolved in service request 28317218. The fixes are attached to the service request. There is no corresponding knowledgebase entry.

Dave Yates
EMC TSE3
Benevolent Host S/W & Mainframe Forum Moderator

Host Systems

Was this post helpful?