This post is more than 5 years old
3 Posts
0
105516
need serial port for optiplex 390 sff
can anybody help
I need a serial port for my new optiplex 390.
is there a connector on the motherbord for com1?
thanks
Barry
This post is more than 5 years old
3 Posts
0
105516
can anybody help
I need a serial port for my new optiplex 390.
is there a connector on the motherbord for com1?
thanks
Barry
Top
speedstep
9 Legend
9 Legend
•
47K Posts
0
February 16th, 2013 22:00
The Serial PS2 Port Adapter from Dell™ adds PS2 functionality to your system. This product has been tested and validated on Dell systems. It is supported by Dell Technical Support when used with a Dell system.Dell Y9001 - OptiPlex Serial P/S2 Add-In Card Assembly
Dell Serial P/S2 Add-In Card and Cable Assembly for Select OptiPlex Systems, Low Profile, SFF, Desktop, MT, Add-In Card, Dell Y9001, N3563.
Part Number(s): Y9001/ 0Y9001 Serial/ PS2 ADD-IN Card, LOW Profile For Dell ComputersCategory: Internal Parts and assembliesSub Category: Boards (Control)Notes: D9906 PWA, I/ O, SER/ PS2, DT, LPF, ULD, N3563 CBL, CRD-SER, PS2, DC431 Tape, ADH, DBL, .045IN THK, VHB, HH, MC355 Brkt, MTG, MET, HH, 2.0, 01157 Stdf, HEX W/ Wshr, 4-40X.250, STLPart Number Y9001/ 0Y9001 compatible with the following Dell Models:
OptiPlex 320, OptiPlex 320 Desktop, OptiPlex 320 Mini-Tower, OptiPlex 330, OptiPlex 330 Desktop, OptiPlex 330 Mini-Tower, OptiPlex 360, Optiplex 390, OptiPlex 740, OptiPlex 740 Desktop, OptiPlex 740 Mini-Tower, OptiPlex 740e, OptiPlex 745, OptiPlex 745 Desktop, OptiPlex 745e, OptiPlex 755, OptiPlex GX520, OptiPlex GX620
RoHe
10 Elder
10 Elder
•
44.5K Posts
0
February 15th, 2013 12:00
Have a look at page 84 in the manual which says there's one PS2/COM connector 24-pin connector on the motherboard.
Alternative might be to install a low profile card with a serial port in the PCI-e x1 slot, assuming it's not currently in use.
RoHe
10 Elder
10 Elder
•
44.5K Posts
0
February 15th, 2013 12:00
And the bottom of page 58 shows the BIOS settings available for the serial port.
bazwilson
3 Posts
0
February 16th, 2013 01:00
Thanks I have identified the connector. Barry
RoHe
10 Elder
10 Elder
•
44.5K Posts
0
February 16th, 2013 17:00
[Y[
Please mark this thread as solved.
bazwilson
3 Posts
0
February 17th, 2013 02:00
Thanks to all who have helped, I have ordered a connector.
Thanks