Unsolved
This post is more than 5 years old
9 Posts
0
3111
NTP Setup on Brocade 5100
Hello,
have two problems:
1. Find Doku for this SAN switch
2. Only first setup with EZSwitchSetup asked for time settings, but where to find datailed setup for time settings, in the webtools?
Thanks so far
Kind regards Andreas
AURcrazy2_087b99
9 Posts
0
October 28th, 2010 06:00
OK then last point is where to get the documentation????
At the bricade side an login needed
Bye Andreas
AURcrazy2_087b99
9 Posts
0
October 28th, 2010 06:00
OK Timezone and so on can setup with CLI
RRR
1 Rookie
1 Rookie
•
5.7K Posts
0
October 28th, 2010 06:00
tsclockserver Displays or sets the NTP server address
tstimezone Displays or sets the time zone
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
October 28th, 2010 13:00
access to mybrocade portal is free, at least documentation section is wide open.
RRR
1 Rookie
1 Rookie
•
5.7K Posts
0
October 29th, 2010 03:00
So create a login account then ! It's free of charge !
DanJost
190 Posts
0
October 29th, 2010 08:00
Woops, I don't see the NTP settings in my web console ... sorry about that.
Dan
DanJost
190 Posts
0
October 29th, 2010 08:00
"Only first setup with EZSwitchSetup asked for time settings, but where to find datailed setup for time settings, in the webtools?"
Dell OEM switches that I have seen send you to the "EZSwitchSetup" by default - not sure how to turn that off, but if you http://youswitchipaddress/switchExplorer.html you'll land in the "regular" management console and you should be able to find the NTP setting in there. Also, if I remember correctly, the default configuration on these Dells have all of the ports "port zoned" to the first two ports.
Dan
RRR
1 Rookie
1 Rookie
•
5.7K Posts
0
October 31st, 2010 02:00
I checked webtools myself - nothing there.... CLI is the way to go !!