Unsolved
This post is more than 5 years old
5 Posts
0
652
Cisco Link Failure Alert Configuration
Hi All,
We have Cisco 9513 Director, and we have all our storage device FA connected to one modules and the servers are connected on a seperate module. Is there a way i can configure the link failure alerts for a specific module alone on a a cisco switch to which the storage fa ports are connected.
Whereas i dont want to enable the link failure alerts for the entire switch. Please advice .
Regards,
Naresh
Cell : +65 84085272
Email : nareshb_2001@yahoo.com
minksg
546 Posts
0
January 11th, 2011 05:00
Hi Nareesh - this question would be better served in the Support Forums..stand by and I'll get it moved.
RFritz11
2 Intern
2 Intern
•
244 Posts
0
January 11th, 2011 06:00
Hi Naresh, I've moved your thread to the support forums infrastructure connectivity where it should get prompt attention. Thanks.
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
January 11th, 2011 06:00
you can setup MDS to send errors to syslog, i am sure you can get creative with syslog where you only monitor specific modules.
DanJost
190 Posts
0
January 12th, 2011 09:00
You can (or could in older MDS) disable link state traps on the ones you don't want to see. It will still show as "down" if you are polling but if you are using traps you can disable the traps for particular interfaces. A quick google of "mds cli snmp" will get you this info.
Dan