Problem Reboot Loop Server 2008

Question

Good morning I have a DELL R510 server with a RAID 5 H700 and Windows Server 2008 x64, I replaced an HDD I watch I did the rebuild and then I restarted it but it does not restart anymore it continues to go into LOOP, in temporary mode it stops on the crcdisk.sys file and reboots.what can I do to get it started? I tried to put the CD and restore but it asks me for the Raid H700 controller drivers, from the dell site I downloaded several but none workswho can help me?thank you

theflash1932 · Accepted Answer

The syntax to extract DOES work - I copied it directly from a working example:   You may need to see if there is an older version of the file if your firmware is out of date (or force the wrong one).

theflash1932 · Answer

Drivers for Windows install/restore:

https://dl.dell.com/FOLDER00353749M/1/SAS-RAID_Driver_93NDM_WN32_4.31.1.64_A02.EXE

You must download and run to extract files before putting them on your installation/recovery media.

miami71it · Answer

thanks for the answer, I found this installation file too, but it does not unpack any driver, it wants to install itself, even if I proceed with the installation from error,
the error message is: this update packege in not compatible with your system configuration

miami71it · Answer

have no ideas?

theflash1932 · Answer

Don't change the subject of the thread ... replying is sufficient or start your own.

theflash1932 · Answer

Extract it manually then:.\SAS-RAID_Driver_93NDM_WN32_4.31.1.64_A02.EXE /e=.\raid /s OR download the self-extracting version:https://dl.dell.com/FOLDER90190M/9/DELL_MULTI-DEVICE_A02_R283424.exe

miami71it · Answer

hello the syntax you wrote me to extract the driver does not work and the self-extracting one is not correct it is always what I find on the dell site but when I select the radi H700 it tells me that it is not correct

PowerEdge Hardware General

Was this post helpful?