Intel Rapid Start Technology

Hi Akram ElShinnawi,

Even though the ‘Intel Rapid Start Technology’ is enabled in the BIOS, Intel Rapid Start Technology software in the operating system should have accelerated the mSATA drive on the computer only then the feature would be enabled in the system. Please follow the steps mentioned below to enable the acceleration.

1. Run the Intel RST software through the charms search bar menu or the task bar icon.
2. Click Enable acceleration under either the Status or Accelerate menu.

3. Select the SSD to be used as a cache device.

4. Select the size from the SSD to be allocated for the cache memory.

Note : Any remaining space on the SSD may be used for data storage using the simple data single-disk RAID 0 volume that is automatically created.

5. Select the drive (or RAID volume) to be accelerated. It is highly recommended to accelerate the system volume or system disk for maximum performance.

6. Select the acceleration mode. By default, Enhanced mode is selected.

Note: Enhanced mode: Acceleration is optimized for data protection.
Maximized mode: Acceleration is optimized for input/output performance.

7. Click OK. The page refreshes and reports the new acceleration configuration in the Acceleration View. Your system is now successfully configured with the Intel Smart Response Technology.

Once this is done the mSATA drive will not be visible in windows.

Hi Ravi ,

Thanks for your aid , I have faced some problems though , first of all I can't run the rapid start technology user interface , brings up the same message " your system does not appear to have intel rapid start technology enabled " then I tried to update the application through dell , while extracting the installer it won't run the setup saying " your system does not meet the minimum requirments " and the mSATA drive is already not visible in windows , any ideas ?

You need to have SSD installed in the laptop for Intel Rapid Start Technology to work. If you have it, try reinstall the drivers:

downloadcenter.intel.com/Detail_Desc.aspx

I had same problem. Go into BIOS on BOOT tab and try SECURE = DISABLED and Op ROM = ENABLED.  If it does work you have the same problem as me. Otherwise put it back to SECURE=ENABLED.

Thank you for your reply , unfortunately it did not work , I tried disabling the secure boot , enabled op rom , but the same error appeared , I put it back to secure boot , any other idea would be greatly appreciated

Hi Akram ElShinnawi,

Since you did not disable the acceleration before re-installing the operating system. I recommend that we reset the ISRT manually. Please follow the below given steps to reset it manually:

• Boot to Bios (F2)
• Change Sata operation to AHCI
• Save settings and Exit
• As soon as the system boots up tap the F8 key to go into Advanced options
• Choose option Repair my computer
• Wait for 3 – 5 minutes on the black screen until the system shows up recovery options
• On System Recovery option click next
• On user name / password option click next (if password has been set for primary user please enter the right password)
• On System Recovery Option screen ------> Select Command Prompt
• At Command prompt type in Diskpart
• Type LIST DISKà You should see 2 Disks listed like below

Please check for the ISRT.

Hello Ravi , I'm extremely sorry for the late response , i had lots of exams lately and i haven't been able to check my mails.

I have tried to do this , only  after I run the command prompt , i only get  Disk 0 , the laptop doesn't read the Msata ,

what should i do ?