Unsolved
This post is more than 5 years old
1 Message
0
68121
August 3rd, 2011 10:00
Optiplex 380 RAID
In the Optiplex 380 Service Manual, under system setup, Drive, SATA Operations it mentions the following:
configures the operating mode of the integrated hard drive controller.
- RAID Autodetect / AHCI = RAID if signed drives, otherwise AHCI
- RAID Autodetect / ATA= RAID if signed drives, otherwise ATA
- RAID On / ATA= SATA is configured for RAID on every boot
- Legacy = The hard drive controller is configured for legacy mode
I haven't been able to find any documentation on the RAID setup. Does anyone know what RAID levels are supported? Also, what is meant by "signed drives"?
There is currently a single hard drive in the system with Windows 7 Professional running on it. I want to add a second hard drive (that is the same as the first) and then have the two drives set up for a RAID 1 (mirrored) configuration. Can that be done with a drive that already has an OS and applications installed on it? Will the RAID setup perform the initial duplciation of the current drive to the second drive when it is setup as RAID 1.
mklassen
8 Posts
0
January 8th, 2015 23:00
> what is meant by "signed drives"?
The setup of a RAiD array writes a "signature" onto each disk-drive that you choose to add to the "array".