Unsolved
This post is more than 5 years old
5 Posts
0
1098
April 4th, 2017 13:00
m17x r2 boot only in safe mode
I`ve tried everything from disconnecting the video card even replacing it, to my SSD , memory, etc.... no luck
it boots in normal window but it hangs there for ever, as for in safe mode it boots fine, help is needed pls
thx
Alienware-Eimy
3 Apprentice
3 Apprentice
•
4.4K Posts
0
April 4th, 2017 15:00
Hi,
Have you reinstalled Windows?
Dj Nadim
5 Posts
0
April 5th, 2017 04:00
Hi
it won't let me reach that point, i've tried many times no luck, i've had it gor 6 years now using it only for Djing on weekend, i have 1 memory slot not working though , whdn i do diagnostic everything shows well no error what so ever
if it runs on safe mode does that means the morther board is fine ?
any other ideas might help pls ?
thx
Alienware-Eimy
3 Apprentice
3 Apprentice
•
4.4K Posts
0
April 6th, 2017 10:00
What do you mean with "it won't let me"?, regarding the reinstallation of Windows. What are you using for the installation (usb or disc)? Does it give you an error?
And no, it is not the motherboard.
Dj Nadim
5 Posts
0
October 13th, 2017 16:00
Hi
Sorry for the delay, I still have the same problem, I`ve received today Nvidia video card, installed it, still same problem, I can boot in safe mode only, I try fresh install of windows DVD, it starts then it stops ,
thx
Dj Nadim
5 Posts
0
October 13th, 2017 16:00
again, it starts then it stops on ( STARTING WIDNWOS )
THX
89fordprobee
1.2K Posts
0
October 14th, 2017 10:00
okay first off ..
-being this is a m17X R2 .. does it have single or dual video cards?
-if single by disconnecting.. do you mean completely removing the card/fan and heatsink out of the system.. since there really isnt any other way to *disconnect*
-if it had dual cards they must be replaced in pairs, i know when i had replaced my video cards in my M17X R1 and r2's eons ago it was both or no post period.. but otherwise same as above and completely removed..
-is video card seen in system bios?
-does it have a dell P/N since other cards without a dell Vbios cause issues
- new or used .... new okay .. used .. might have problems aswell
-running in safemode means its not loading drivers or software , so its not directly controlling the devices..
-if you disconnected the hdd/ssd sure wont boot will say that .. so its possible windows has a virus/corruption ..
-depending were the ram is didnt you remove all, does it beep on post? (board see's that ram is missing) ..
it goes on and on on trouble shooting.. it could be right down to bad ram.. you said a slot is already bad.. maybe the board lost another, maybe ssd is got issues and they do go bad, and reason windows wont post or install... tried installing on another drive?.. all else fails try a Linux bootable disk/usb and see if it loads and runs .. since it will load everything into the ram with all drivers etc.. this will also help with determining which way to look for issues whether hardware/software or drive..
Also its possible the dvd you have is bad