Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Article Number: 000132989

PowerStore Alerts: Embedded Module State Failed

Summary: Node's IOM has failed. ICW HW check error - Fault Status Register FLT | Embedded Module.

Article Content

Symptoms

When Dell PowerStore encounters a problem, an error alert is generated to help identify the issue. This article explains the different possible causes and the relevant solutions for these error alerts. If your problem is not resolved despite the solution provided, check the technical support contact options.

 

SLN320676_en_US__1icon Note: Can't find the information you need? Let us know via the feedback form at the bottom of this article.

 

Alert ID XMS_IOM_FRU_STATE_FAILED
Alert Text Node's IOM has failed.
Error Code (0x00309203)
Resolution Cause
Embedded module failed state alerts occur when the system firmware detects a problem during self testing which run on power up and on every reboot. The platform software monitors the firmware for these errors and will report them by raising the alert as well as setting the FRU health state to FAILED.

For systems which have not been configured, the Initial Config Wizard runs a Health Check which also checks the firmware for errors and will report the appliance in an "Unconfigured Faulted" state.  Appliances in the faulted state cannot be configured. The error condition must be resolved before you can complete the configuration process.

For some classes of errors, the firmware may indict multiple FRUs because it's not technically possible to determine exactly which FRU caused the error.   For example, if the firmware detects a PCI error for the 4-Port Card, it's not possible to determine if the 4-port Card, the Embedded Module,  or the Node is the cause of the issue.

The same issue is seen on 'svc_diag list --icw_hardware'  output on the service container in the section: Node A|B Fault Status Register as: 
FLT | Embedded Module
and possibly some of the following will also appear:
FLT | I/O Module 0
FLT | I/O Module 1
FLT | 4-Port Card
and possibly: 
FLT | Node



Solution
Resolving these errors may require replacing the embedded module or in the case of multiple FRU indictment, potentially the node or the attached 4-port card. There are also some known error conditions where it's possible to clear the condition without requiring any hardware replacement. It is recommended to contact Technical Support so they can review the underlying cause of the error to determine the best course of action.
 

 

Article Properties

Affected Product

PowerStore

Last Published Date

21 Feb 2021

Version

4

Article Type

Solution

Back to Top